Victron MPPT Charge Controller BT VE.Can 250/70 85 100

Victron MPPT Charge Controller BT VE.Can 250/70 – 250/85 – 250/100 (12V – 24V – 36V – 48V) with MC4 or Screw connectors

NOTE: Software tool is required to select 36V

Ultra-fast Maximum Power Point Tracking (MPPT)
Especially in case of a cloudy sky, when light intensity is changing continuously, an ultra-fast MPPT controller will improve energy harvesting by up to 30% compared to PWM charge controllers and up to 10% compared to slower MPPT controllers.

VE.Can: the solution for multiple control
Up to 25 units can be synchronized with VE.Can and up to 10 units with Bluetooth.

Advanced Maximum Power Point Detection in case of partial shading
In cases of partial shading, two or more maximum power points (MPP) may exist on the power-voltage curve. Conventional MPPTs tend to lock to a local MPP, which may not be the optimal MPP. The innovative SmartSolar algorithm will always maximize energy harvesting by locking onto the optimal MPP.

Ultra-high conversion efficiency
No cooling fan. Maximum efficiency exceeds 98%.

Flexible charging algorithm
Fully programmable charging algorithm and eight pre-programmed algorithms, selectable with a rotary switch (see manual for details).

Very high electronic protection against:

• Over-temperature protection and power derating when temperature is high.
• PV short circuit and PV reverse polarity protection.
• PV reverse current protection

Built-in Bluetooth Smart
The wireless solution to set up, monitor, update and synchronize SmartSolar charge controllers.

Internal temperature sensor and optional external battery voltage, temperature and current sensing via Bluetooth
A Smart Battery Sense, a BMV-712 Smart Battery Monitor or a SmartShunt can be used to communicate battery voltage and temperature (and current in case of a BMV-712 or a SmartShunt) to one or more SmartSolar Charge Controllers.

Fully discharged battery recovery function
Will start charging even if the battery has been discharged to zero volts. Will reconnect to a fully discharged Li-ion battery with integrated disconnect function.

Ve.Direct or VE.Can
For data connection via cable to a Color Control GX or other GX devices, PC or other devices

Optional: SmartSolar pluggable LCD display
Simply remove the rubber seal that protects the plug on the front of the controller and plug-in the display.