Victron MPPT Charge Controller BT 450/100 450/200

Victron MPPT Charge Controller BT 450/100 and 450/200 Battery Voltage 48V

Solar Charge Controller with Ultra-fast Maximum Power Point Tracking (MPPT)
The MPPT RS SmartSolar is a 48V solar charge controller with an input up to 450 VDC and an output of 100A or 200A. It is used in on-grid and off-grid solar applications where maximum battery charging power is required.

Multiple and Independent MPPT Tracking Inputs
Thanks to the multiple MPPT trackers, it’s possible to optimize your solar panel design to achieve maximum performance in your location.

• The MPPT 450/100 model has 2 MPPTs
• The MPPT 450/200 model has 4 MPPTs

Isolated PV Connections for Greater Safety
Complete galvanic isolation between PV and battery connections provides greater overall system safety.

Wide MPPT Voltage Range
PV operating range from 80 to 450 VDC, with a PV startup voltage of 120 VDC.

Lightweight, Efficient, and Quiet
Thanks to high-frequency technology and a new design, this powerful 100A model charger weighs only 7.9 kg. It also has excellent efficiency, low standby energy consumption, and very quiet operation.

Display and Bluetooth
The display reads battery and controller parameters. These parameters can be accessed from a smartphone or other device equipped
with Bluetooth. Bluetooth can also be used to configure the system and change settings via VictronConnect. PV insulation resistance monitoring for peace of mind with high voltages The MPPT RS constantly monitors the PV module and can detect any faults that may reduce panel insulation to unsafe levels.

VE.Can and VE.Direct Port
For connection to a GX device to monitor the system, collect data, and update firmware remotely. VE.Can allows up to 25 units to be connected in parallel and synchronize their charging.

I/O Connections
Connections for programmable relay, temperature sensor, digital inputs, and voltage sensor. The remote input can accept Victron’s smallBMS and other BMS with a “charge allowed” signal.